Wish I had $250..... I think my fake Weber is crap.... :mad:
Thanks man. Got a radiator and gonna slap it in tomorrow. I'll probably try and figure out the engine issues on sunday. It's technically...
Grabbed a stock radiator for $30 locally, gonna try that out. Should work fine... but we'll see when I bolt it all together. Those aluminum...
Had 'em on my old '71 240z.... badass rims. Always liked the look of 'em. Nice choice.
Radio? ;)
Right, but the passenger side is after the pump, and the driver's before. Was just thinking that it would preserve the correct routing, since the...
I saw a pic from another truck that had that pipe going from the front cover to the opposite side of the block - and the hose attached to that....
OK - here's another question, same sorta subject. There are two radiator hoses attached to the block. There are 4 heater hoses, one that comes...
I'm assuming that since 99% of the radiators fit 84-95 and only a couple fit 79-83 that they don't interchange. :rolleyes: Otherwise, this is...
Not gonna make it, my truck runs like crap. Not sure it would make it to the store on the corner right now... especially with a hole in the...
I've read a post on another board a while back about swapping a Tacoma radiator into an earlier truck. This guy did a 2rz swap into his (I think)...
It runs. Like crap, but it runs. Seems that the *ahem* Weber I got is a dud. Having fuel issues, bigtime. I can get it to idle at about...
Anyone have a pic of the throttle linkage setup on an installed Weber? My kit has the normal parts but the assembly instructions SUCK. If I use...
That's the only shorty type header I found. Looking for something more solid and reliable than the stock manifold, but keeps the noise down a...
http://www.autopartswarehouse.com/sku/Toyota/Pickup/Hedman/Headers/1980/SR5/4_Cyl_2-dot-2L/H5639400.html?tlc=Engine+%26+Drivetrain Thinking about...
So as far as vacuum routing, I am running the stock dual diaphragm distributor. One is a retard and one is an advance. if I remember right the...
Yea but does it fit over the hub? If those ar 17's or 18's they'll probably fit over the ball joint fine. It's just a question of the depth and...
I got steel 15x6 wheels off CL for $50 for the set. The backspacing is 4", fits really close to the stock wheels. They look really nice, just...
I slapped my Jeep wheels on and they look great. Only issue is that on the back, the wheel curves in a little and hits the edge of the drum...
360 is half the state. I'm in Vancouver and my area code is 360. Isn't Blaine 360 also? I think WA state was divided into 2 area codes forever,...
Separate names with a comma.
