The Ontario pick a part is having one the 23rd & 24th weekend.
Ok thanks for the input. I probably will just stick with the tire size that I have. It would be cool to have an 18/20 combo but not if im going to...
Found this while looking up gear ratios, maybe it could be some help for you in figuring out the 94'...
Nice:waytogo:
So as I am finnishing up my rebuild and getting my truck back on the road, I'm looking into getting new wheels at the end of summer (once bank...
User Name: patrickgraven Name: I think it is obvious:funnyup: Age:34 Location: Eastvale (Just north of Norco on the 15)
I looked at the pictures of your trucks in your 87 thread and you difference could be due to tire size. I dont know what the ratio is for the 87,...
that valve cover looks pretty cool. Also wish I could find a set of door panels like that for mine.
So today, I started it and it sounds good!!!!!! Just need to adjust the valves and take it for a spin. I was kind of nervous when I turned the...
well I went to flip the blocks around and it looked like it would move the axle to far forward, plus the offset on my wheels are too deep so the...
Thanks, tomorrow is the big day. Once I flip the blocks and fill the fluids I will be starting it for the first time. Hopefully I put it all back...
dont worry about it. I figured since the blocks on my suburban go one way to lift it, that they would angle the go the opposite.
ok cool thanks
So I installed the blocks (4" beefy taco) on my truck that I got from dgrfan55 this week and I have a few questions. First I installed them with...
And finally where we left off last night until today. I didnt get any after I was done (it was dark by then). But tomorrow I need to run by the...
Next since I built it inside a house I had to get it through the door, so engine stand was pushed as far as it would go through the door then the...
Once I got the pistons in then I finished the short block. I didnt take any pictures of the head going on, but the last is the complete engine on...
so over the last week I have been assembling the engine in my girlfiriends living room. I got the flywheel resurfaced and new injectors this week...
Thanks for the help everyone. I got in in without removing the transmission. I got real close yesterday and just used the bolts to pull it together.
So I got my engine back together and almost put back in the truck. Now I cant get the engine and transmission back together. Is there a trick to...
Separate names with a comma.
