Hmmm looks like those are for attaching the wiper motor to the firewall or fender. I'm looking for the phenolic bushings on the linkage. But...
Im in the process of modernizing the wiper system in my 76'. I added a MaxxTronic delay module and was in the process of upgrading the motor when...
Has anyone ever seen one of the old dash clocks pop up online? I remember reading somewhere that they were JDM only, but I'd love to get my hands...
@jetas - Quick follow up question on this. Did your truck have a clutch safety switch? If not, did you wire one in? And if you did, how did you...
All good info. I'll have to take a peek to see which cars the 84+ guys are picking them from. Having a model and year range to start from would...
Has anyone installed a rear sway bar on their Gen II before? I've already upgraded my front bar to a 30mm out of a early 90's GMC and looking to...
Incredible. Thank you! Got next months project all lined up now.
I guess that is an option too! I'm less concerned with the cost of a new harness than I am with having it be totally reliable and easy to find...
Confirms what I was already thinking. At this point it's worth the work if I don't have to deal with the factory wiring anymore. Thanks all.
Thanks Jetas. No emissions testing, thankfully. So hopefully that simplifies a potential install a bit. As for separating the harnesses, that is...
I suspected a fuseable link as well. I believe there is a heavy white and a heavy red/blue wire off the positive terminal. The heavy red/blue has...
Has anyone installed a Painless wiring kit in a second gen pickup before? How hard and/or time consuming was it? I've just about had it with the...
Anyone have any recommendations on a breather for the front of a 20R that isn't the K&N? I'm looking for something that looks a bit more factory...
Posting here for posterity. If anyone else runs into this problem, the issue was the tail shaft seal. Apparently the Timken 710319 ID is too small...
Took the output shaft seal out tonight and the yoke fit perfectly. Output shaft and driveshaft spin freely and easily. So I guess it was the seal!...
I haven't tried greasing it. Open to trying it though! I'm concerned that something may not be right with either the trans or the yoke because it...
In the middle of swapping out my L43 to a W55. Went to mock up the driveshaft yesterday and the front yoke won't go more than an inch or so into...
HAs anyone added aftermarket cruise control to your rig? If so, what system did you go with?
Well engine and trans are in and it's still rubbing. Apparently I really fucked up the install haha. Going to pull them out and try reinstalling...
I know, right? They are the old springs. I literally just painted them and put them back in. Same issue on both sides even with the shocks...
Separate names with a comma.
