Thanks Fred. Ill give it a shot with just the black striped wire first since this time I’m lucky enough to have the same wire color as somebody...
Will do. I'll figure the wiring out tomorrow and see which wire I need and which I do not.
I'll mess around with the multimeter tomorrow and get the battery reconnected. Thanks jetas
Thanks for a quick reply Fred. Could I just run both to the connector and call it a day? Or would I need to test for voltage and ONLY run ONE? I...
Im at the final 5% before the first startup and I am unsure of how the 2 OE carb connector wires connect back to the spade connector to the...
Cool, I just wanted to see how other people routed the lines. And I for sure need to clean out the heater. I’m sure it’s worse than what I would...
Thanks for explaining the routing, sometimes the diagrams are hard to see with all the stuff there. Ill work on routing them tomorrow.
Thank you again jetas. I have that picture but does the reed valve line connect to the OE carb? I just couldn't tell in the picture.
I’ve tried all over other forums and here (obviously) to find out where a couple of coolant hoses are routed after doing a desmog but haven’t...
Did you mount yours in the tank? Also is the wiring bad?
Should I not use the regulator on it? Would it negatively effect performance?
Routing the fuel lines seems to be a lot more confusing than expected. I’m unsure if I have any of them routed correctly, and between the...
Awesome thanks for a quick reply jetas
To those who helped with the engine mating process, thank you. I pulled the transmission out and reattached it that way and the whole assembly is...
Long update: I realigned the clutch assembly with the alignment tool and tried to get the engine back in the truck with no luck. The fitment on...
Going to try an alignment tool if it doesn’t work out tomorrow while fiddling with it some more. wish me luck
The machine shop that assembled the whole thing used one of those alignment tools, because they sent me a picture of it still attached to the...
Thanks for the pictures, helped me out, before I try it again Ill definitely clean the shaft off since I didn't think about it the first time for...
Yeah I'll double check it, but it looked dead on straight when I checked it. Then again the eye can only see "straight" so well.
During the rebuild that the machine shop did, I paid extra to have them install everything just for this reason, so I wouldn’t mess the assembly...
Separate names with a comma.
