I read an article the other day about individual cylinder tuning. on a hand built perfectly in spec v8 race engine AFRs ranged from 13-1 to 15.5-1...
Throwout bearing should not be audible without some pressure on the clutch pedal unless the hydraulics aren't fully releasing. Driveshaft carrier...
Ask him where the battery is. then start the stopwatch LOL. Depending on the exact trim and model it's either A. passenger side in the fender....
Before you read this: I haven't used their stuff, I'm only going from my knowledge of cars, electronics, and their vague-as-heck descriptions and...
What were they supposed to do to the block exactly/what did you pay for them to do? I wonder if they know there's supposed to be some sort of...
you don't have to torque the other caps, just get then snug (5-10 ftlbs???) and slide the crank lengthwise to seat the thrust bearings (hello...
they're all over ebay. haven't heard much. short-tube 4-1 great for top end, bad for low end/powerband width. O2 sensor reading 1 cylinder=fail
the hunting idle is definitely the idle adjusted too high. can you drive the screw in until it stops? (it will be easily turned till it stops...
I'd ask your next machine shop about the rod. I think it'd be OK but I'm not an expert there. 30 minutes in any cleaning situation, whether it's...
What happens if you take off without the skinny pedal halfway down? you know, like a normal person not trying to get tickets....
How are you figuring you still have a problem? you only need to disconnect the ECU for a few seconds to clear the code. if it's still there, it...
I just checked half a dozen cars at rockauto, MKIII supra turbo (has R154), the p/u, 4runner, 98 taco, etc....all have 5/8 bore master cylinder....
there's no one answer to the CFM question, it depends on the particulars of your truck like if you've got AC and how well your cooling system...
Methane ;) alternative fuel credit for CAFE lol Nice video, I laughed.
I don't see any reason to change the ductwork in the cabin, just take the actuator off the door directs airflow from the AC evaporator and glue it...
Name: Russell Location: Carbondale, IL Contact: PM or email my username @yahoo.com shipping: included for lower 48 My truck was acting up, I...
DO EEET keep in mind the drag at high speed is gonna be incredible... big single :-D
except you won't have a code for fuel pressure. What happens if you keep cranking for several seconds the first time? I have the same problem...
valve stem seals don't see pressure though. if anything, they see vacuum and are there to keep oil from getting sucked in. blow by is rings. BTW...
This is from memory, so it's pretty good but not gospel. If you're looking for it for the '82 in your sig, you'll need a driveshaft. AFAIK the...
Separate names with a comma.
