One of my buddies in Tennessee bought a bunch of loaded bolt bins at an auction a couple weeks ago. What he didn't know at the time was there...
Pull the driveline, put a jack under the trans. Remove everything attached to the trans. Starter, slave cylinder, shifter, speedometer cable etc...
G series and W series share the same trans face pattern minimum from my 84 till 2000 or so.
The old truck still gets the job done. Cleared out my storage unit in preparation for a move. Lots of stuff is headed to the scrap yard monday...
I run these up front.
Drop arms up front and blocks out back but you'll need a notch to clear the rear for sure.
If you can do minor fabrication I wouldn't waste your time with drop leaves. Get some 4x4 leaves from the same generation truck and shorten the...
I have kyb monomax all around and the front isn't too bad. They are a decent match to 1 ton torsion bars. If i stick with the standard type...
So I've been half assed looking for rotors for a proper rear disc conversion. These fell into my lap last night. [IMG] I hadn't thought of using...
I've had good luck with the standard clutches at oriellys. I'm actually running their pressure plate on a 6 puck ceramic disc and 9 lb aluminum...
What exedy clutch did you go with? Marlincrawler.com carries Aisin seico clutches. Marlin recommends having the flywheel step at .026" rather...
:lol: yea that too! That's what I get for posting while pumping gas.
You probably don't need both the slave and master but heck the system will be open and they're easy to change. To figure out which one it is...
You need to do 2 things. First off find a new mechanic shop, your current go-to isn't worth their weight in rabbit turds. Your truck has an...
Then I got nothing. :lol:
Does the engine have a slight miss at idle? Is there a slight miss at lower rpm (sub 1000) steady throttle? Does the engine run smoothly...
Odds are that it's just like 95% of the 22re's out there and it needs an injector service.
Sway bars for sure, I ran spindles for a while but their ackerman angle was crap for racing so I pulled them off. They were fine on the street...
Yup torsion bar adjustment only changes ride height unless they are cranked up till the droop bumpstops are being compressed. Change the...
3500 Canadian so that's like $350 American right? Sweet, see ya next weekend! :lol: Looks like that's about $2700 American, not a bad deal at...
Separate names with a comma.
