Glad you got it fixed finally. Amazing what bad geometry can do for drive ability eh?
Search "sticker bomb wrap" on amazon and you'll find what he used. I get my leds from superbrightleds.com I've yet to have an issue with them and...
If you have the rubber isolators on the springs there is NO need to drill your blocks to fit the isolator in the block. Remove the isolator and...
They are all different. My 84 x cab has 3" blocks and trimmed stock bumpstops and it hits the stops more often than not. My 89 has 4x4 leafs,...
Sachs makes a fine clutch. Let me guess the shop recommended a different clutch that they carry right? :lol:
If you're already replacing the core support just go ahead and replace the whole front clip. It's only 20-30 more spot welds to drill and the...
There are lots of threaded holes in the inner fender and core support. I've always had good luck bolting tabs to those holes (sometimes 2 or 3 at...
About 2"
[IMG] About an inch lower than that. :lol: since that picture I made some 4" angled blocks for it. The lip of the wheel is just a tiny bit...
Look in my build thread and you'll see how low you can go with a simple mini notch and still have an unmolested bed.
I never waste my time with a full rebuild since toy trannys are very easy to find in my neck of the woods. But, if I was to getting one done...
Speedwaymotors.com carries them.
Yup short to the front, tall to the back.
Yes it'll work just fine, go get it.
Yes it has to be from a 2 wheel drive to be a direct fit.
Narrow to the front to point the pinion back down at the trans output.
Ever watched supra guys ripping off sub 10 second passes? They're mostly running the same ring & pinion just in an independent configuration. The...
Right on but you didn't answer the important question about the current trans. If it's a 4 speed your current rear end will hold up to some...
Oh yea I forgot you had that truck. Putting a small block in it or something more exotic? Factory 5 speed? If so you'll want to change that rear...
Pfft I have no idea. :lol: I put a straight edge across the back and it's 5" to the mounting surface and the wheels are 15x8's that's all I...
Separate names with a comma.
