Hey Fred, you left out the coil wire. Igniters can cause silly misses as they slowly die. Sometimes they just die, sometimes they drop out as they...
Igniter!
Did you install solid motor mounts? They appear stock in the video. I had a set of Trail Gear 'Bombproof' motor mounts and they were hideous!...
Not really motivated to sell it. But, the condition is average and the thing could use a good cleaning. A few odds and ends to work on like most...
Things I've come across that sound like your issue. The flywheel installed off clock, not so evident with most 4 bangers, but if the flywheel was...
Thinning my stable. For sale an '86 4Runner. 22RE, 5 speed, 4WD. Runs and drives good. Just passed Cali smog and registered through June '22....
Uh, not really. Too bad 99.9% of the people that own I.C. vehicles believe that.
If your engine is stock, 8.4 to 1 comp ratio, 87 octane is more than adequate. If you are having detonation issues with a stock 20R consider...
Not to step on your toes on this, but, most of the LEDs available for use in our vahicles, and a lot of the 12v LEDs I've bought for my outside...
I adapted a 22R mani to a Weber. Bolts weren"t too bad but the mani had to be cut to fit the Weber's throttle bores. The manifolds were much...
Sounds like an issue on the ouput shaft of the trans. If the sound changes with load and is not affected by the engine RPM I would suspect a...
Screw rhe adapter, get the manofold. Canon or Offenhauser, I've had both in the past. Offy offered a dual plane for the 22R that separated the...
Axle housimg swaps would be limited by the spring perches, unless you want to cut and weld. Other considerations would be the length. An '86 4X4...
I tried KYB Exel G and found them to be junk, even as a stock replacement shock. Wouldn't recommend them for anything. KYB Gas-A-Just has been my...
Why the STIFFEST shocks? Try to find dampers that are valved for your application. Just going stiff can kill whatever your suspension mods were...
If the case is aluminum it is likely a W40 or W42. In which case the most you might have to do is redrill the rear mount holes in the crossmember...
is your trans cast iron, G series, or aluminum, W series?
Have to ask, What trans are you starting with? 4 speed is a bit vague.
Might work with an adapter plate, but I woulldn't recommend it. T50 has great ratios, but it's a bit on the weak side. Best bet is a W5X. Celica,...
I believe the R family engines have the same bolt pattern for the bell housing. Issue may be the rear mount.
Separate names with a comma.
