There is a V8 Hilux involved in tarmac rallying in NZ, google up "Stuart Rose's V8 Hilux" and a couple of Youtube links should come up. Haven't...
Build thread here - http://www.toyotaminis.com/forum/showthread.php?t=6279 Got a build thread on the Corolla anywhere? My other project at...
Sweet to see another V8 Corolla on this site. :cool: Keen to seem some details on the IRS swap, is it full width or has it been shortened to...
If you want I can grab some measurements from my Corolla (running Surf/4 Runner tailgate) to let you know the clearance you need for the tailgate....
Cool conversion, especially witth the coilovers and motor swap. A mate did one similar but retained factory style suspension. [img] [img] [img]...
So no pics, but new batteries have arrived. Small but heavy, should do the job at 400CCA each. Had a planning session with the panelbeater on what...
Yeah they swing down quite a bit, could set it to drop only so far down and have the tray floor drop at the same time. If its bagged though you...
You going to retain the opening tailgate or are you just after the electric rear window? I know there is a later model Surf/4 Runner with one...
Took the wife shopping in Tauranga yesterday (about 180 miles from home), well thats what I told her. Really I just wanted to go to Burger Fuel...
Manual or auto choke? Sounds like the auto choke is buggered. Callum
350Z wheels are around 30P offset, not sure on the 370Z but would expect to be similar. Callum
Sorry, I was referring to the centre bore on the bolt on adaptor, I think they are either 64mm or 67mm for the Hilux. Callum
I ran these - [IMG] on my 1984 YN57 Hilux with 205/65's on them. They are a 15x7 with 25P offset, only issue is you can't run the factory centre...
I'm sure the centre bore on those is too small to fit a Hilux, can't remember the measurement off the top of my head though. Callum
Depends what it is, I know the www.minitruckin.co.nz and www.downundertruckin.com guys have shipped a few bits to the States for people. I'm not...
Axle stands under the front, put your trolley jack (or even scissor jacks) under the rear to take the weight there. Callum
Yeah Australia has a reasonable local auto industry with the Ford Falcon and Holden Commodore, some bits (such as the V8 engines) are imported...
I would expect for a minitruck you aren't building it to be a road racer, the whole point is to be cambered out at both ends. So my approach would...
The Celica Supra rear is what I used in my Starlet, I put the whole floorpan in though. They are a semi trailing arm setup and camber up badly...
Yeah its from an Australian Ford Falcon BA V8, I already have a fibreglass copy of the bonnet hump molded into my hood but want to go all steel as...
Separate names with a comma.
