Forgot where i left off but got the floor all mapped out out and welded most of it in.built the tunnel made some engine mounts and finally for now...
Sorry i haven't been on here in a while had to fix the 84 and pull an engine for the swap in my 94 and just been working a way on the 74 been...
i would have to bad i hit him and then he sling shotted into the next lane and got hit by an f150coming the other direction....no chance for...
So..left work tonight not 5 min down the road 200 lb buck dive out in front of the white truck and wipes the front end out so now i know what im...
i might have a set let me take a look
i can take a look i think i might have one
no i didnt have to do anything i still have to adjust and build control arms for the front. theyre the perfect width for the way the trucks set up...
600 is really cheap,no theyre 5x114.3mm which is the same as 5x41/2 just have tp get toyota specific lug nuts with a colar to run them
They were 220 a piece shipped to my door then i wrapped em with nittos i gotta order 2 more tires
Im about at the spot where i need wheels top start mocking up the truck and since i don't have much room i can't run too wide of a wheel.I was...
my friend who had an isuzu that he was building for almost four years which if it was finished would have been insane was trying to sell these...
we cut the floor out of the bed amnd the easiest way to square it up was upside down. made the cups to hold the upper four-link arms its 21/2...
made the lower four link mounts so they'd slip over the driveshaft hoop so it'd be easier to adjust to mock everything up and it'll be much...
set the cab on end reinforced the cab so it wouldn't buckle when i cut the floor out. cut it all out and set it on the truck to get the effect of...
i got the notches together except for the bottoms ill do that when i can flip the frame over and weld them fully i got the upper and lower link...
thanks i've been through your thread i like you fab work and the way you layed out your truck. you have alot of time in that thing lookin good
My buddy who is helping me with the lay out of this truck has a 99 s10 bagged and bodied on 20s with almost a full frame and 350 fuel inject swap...
we started by making the carrier bearing cossmember out of 1.66 same stuff i used for my tube bed on my 84. and we cut out the rear tire carrier...
once we got it all torn down to bare frame we started going over it and there was absolutely no rot at all on the entire frame , which was very...
Honestly i got em for like 30 bucks one was bent and my buddy at the metal shop fixed it but theyre some discontinued 19" the offset is way to...
Separate names with a comma.
