Well I just replaced the temp sensor, h20 pump, coil, wires and plugs when I rebuilt the engine (about 10k miles ago). I changed the fuel filter...
So on my way home today after getting gas the truck began to miss for a split second and the check engine light came on and went off. About a half...
sold!!!
bump $30
Sorry I didn't get back to this sooner. But the diagram was a little confusing and I haven't looked at my truck with the diagram. But from what I...
Tailgate is sold.
From what I remember the headlights are attached to the body harness, I just don't recall how the engine harness attaches to the whole system.
Do you have a factory wire diagram? I would think you could leave the engine wire harness attached to the engine when you pull it and go from...
I recently picked up a shaved tailgate so I have my stock one available. It is currently primered black, but is in very good shape with no dents....
do you mean 225/40R18? I have those on the front of mine and they are almost stock height. As far as your bed if the sides are in good shape why...
I picked this up a few months ago to use on my truck, but since I picked up a shaved tailgate I don't need it anymore. Its made my AVS and fits...
So its been a while since I have updated this. I haven't driven the truck since april as I cracked the head. So while It has been down I have done...
And finally here is how I did the panels. I went to lowes and crown moulding trim pieces and wrapped them in tweed and screwed them to the door. I...
Here is the inside of the door. When I removed the power reg I carefully removed the clip from the door so the factory clip (that attaches the...
here is the factory connections I used. Both from the harness and from the regulator
Here circled is the only part of the door harness I used. I spliced together the aftermarket harness and the toyota plug together.
In this picture the yellow circle is the after market wire connector. The red circle Is where the switch connects to the factory regulator. The...
Here is a picture of how the power regulator mounted in my manual doors. The yellow circles bolted in no problem. The red circles are where I had...
Sure. It will be a couple of days, I need to pull the panel off. Figure I should have some pics since I keep commenting on these threads.
What I did was I took the harness out of the door (plugs for windows and switches) and was going to try and use factory switches. I looked at the...
Separate names with a comma.
