I knew the crossmember had to be modified, I thought maybe 1.5" to 2.0" drop. Did you have to modify the trans crossmember to obtain correct trans...
Ditching the 7MGTE and swapping in a GM 5.3. 7M is solid (complete rebuild) just lost interest in it.
I'm doing same swap. Which oil pan did you use? I using the Holley oil pan. Thought by using it I would be able to install engine at a lower...
I'm going to do the same swap. But going with a 4.8l. Have T56 trans and everything to go along with it. Paid big bucks for trans. Later found out...
Need 8 inch rearend from 1989-1994 pickup. Gear ratio does not matter. Would like rearend without ABS.
Check out utube "wiring a 7mgte" only need about 4 wires to get it running.
Don't know if you have obtained the DOM you needed or not but I have ordered all my metal from a company called 'onlinemetal' or it may be...
Not quite sure of the clearance that is needed at the firewall. But I was told you would need a 1 inch body lift kit to clear the transmission at...
I think the Toyota V6 radiator may work for you. For me I had one made. Also the supra radiator may work. I did the same swap about 8 or 9 years...
IronNam, are you running 18x10 on all corners of your truck? I just posted a question asking if 18x9 fit on the front. if you are running 18x10...
I have a 1990 Toyo ext. cab. I know this topic has been covered over and over again. I just can not seem to find the answer to the question about...
I have a 1990 ext-cab which had a 22RE engine with 5sp tranny. Well I guess it has a 7.5" rear-end in it. I will be very soon doing a LS1 swap....
Not yet still gathering parts for swap. Just about have them all. When I begin I will document it.
It's been a while since I have been to this site. Years ago I swap a 7M into my 1990 ext. cab 2wd. Lost interest in project and pushed truck into...
About 5 years ago I started a swap on my 1990 ext cab pickup. Installed a 7MGTE and over the years just lost interest in it. Only need to mount...
I have a 1990 Ext. Cab Pickup. Swapped a 7MGTE into it about 5 years ago. Did the 4 runner front end change using some aftermarket fenders which...
I have swapped a 7MGTE into my truck have not got it running yet, but i too will be going with IRS. I'm looking into IRS from late model Shelby...
Checkout twisted minis. This is what I am going to do to add more clearance because I will be lowering my engine about 1 1/2 inches. Hey by the...
check out this web site for using 1 ton rearend http://www.supratrucks.com/toyota_pickup_with_7mgte_supra_t.htm
Hey Dcups What is the size and offset on those starion wheels?
Separate names with a comma.
