Search Results

Search Again
Page 6 of 6
  1. aaron_sk
    Post

    1977 20r Exhaust Manifold Question

    LCE has a fairly economical set of head studs. You can also get them OEM through a dealer. The price is a bit steep for what they are but they are...
    Post by: aaron_sk, May 16, 2015 in forum: Engine/Drivetrain
  2. aaron_sk
    Post

    what trans do I have

    GL-5 does not directly supersede GL-4, and the GL-5 is notoriously hard on synchros.
    Post by: aaron_sk, May 15, 2015 in forum: Engine/Drivetrain
  3. aaron_sk
    Post

    1978 toyota pickup sr5, polished T(u)RD

    I will freely admit that I am not an engineer and my statements are anecdotal based on my observations, but that said, here are my thoughts on the...
    Post by: aaron_sk, May 15, 2015 in forum: 1976-1983 Build-Up/Project Threads
  4. aaron_sk
    Post

    1978 toyota pickup sr5, polished T(u)RD

    Very clean truck, it will be a blast with that hybrid in it. I must say though, I agree with White Trash about the flex-fan. They are second...
    Post by: aaron_sk, May 14, 2015 in forum: 1976-1983 Build-Up/Project Threads
  5. aaron_sk
    Post

    Clutch fan

    Did you replace the water pump when you did the timing chain job?
    Post by: aaron_sk, May 14, 2015 in forum: Maintenance/Repair
  6. aaron_sk
    Post

    what trans do I have

    Toyota spec for the W55 is 2.7 quarts of 75W90 or 80W90 depending on climate.
    Post by: aaron_sk, May 14, 2015 in forum: Engine/Drivetrain
  7. aaron_sk
    Post

    253 swap

    This swap is into a later truck, but the basics should be the same: Holden V8 in '95 2wd hilux extra cab conversion
    Post by: aaron_sk, May 13, 2015 in forum: Engine/Drivetrain
  8. aaron_sk
    Post

    what trans do I have

    Open the drivers door and look for the tag with tire pressure, barcode, VIN and other info on it. Below the bar code will be a list of codes...
    Post by: aaron_sk, May 13, 2015 in forum: Engine/Drivetrain
  9. aaron_sk
    Post

    Clutch fan

    The clutch can be replaced independently of the fan blades. As was mentioned above the fan freewheels below it's cycling temp. Does the engine...
    Post by: aaron_sk, May 13, 2015 in forum: Maintenance/Repair
  10. aaron_sk
    Post

    1977 2wd hilux build

    Even the stock downpipes stick down below the framerail. I have had both the single and dual-style pipes on my truck and both were notably lower...
    Post by: aaron_sk, May 13, 2015 in forum: Pre-1975 Build-Up/Project Threads
  11. aaron_sk
    Post

    253 swap

    Australia. ;) This guy did it in an RN80: Holden V8 in '95 2wd hilux extra cab conversion
    Post by: aaron_sk, May 13, 2015 in forum: Engine/Drivetrain
  12. aaron_sk
    Post

    FS: VA 1Ton parts

    Any idea on what shipping cost would be to 98403?
    Post by: aaron_sk, May 12, 2015 in forum: Parts and Accessories
  13. aaron_sk
    Post

    AssYriaNrocKer's 94 SingleCab Build Thread

    No reason to ever remove EGR on any vehicle unless it is used only for wheeling (never get into cruise circuit so valve will never open) or on a...
    Post by: aaron_sk, May 12, 2015 in forum: 1989-1995 Build-Up/Project Threads
  14. aaron_sk
    Post

    Toyota hilux backfire on acceleration

    Sounds to me like the secondary is not opening, or possibly clogged jet as was mentioned earlier.
    Post by: aaron_sk, May 11, 2015 in forum: Maintenance/Repair
  15. aaron_sk
    Post

    1976 Pickup nothing special

    That's a shame. Properly built the Buick 3.8L is a fantastic motor, but it sounds like you had a real hack on your hands. Truck looks good. I...
    Post by: aaron_sk, May 10, 2015 in forum: 1976-1983 Build-Up/Project Threads
  16. aaron_sk
    Post

    1976 Pickup nothing special

    Was that 231 set in there with Downey mounts by chance? If so I would be interested in buying them off you if they haven't already been scrapped!
    Post by: aaron_sk, May 9, 2015 in forum: 1976-1983 Build-Up/Project Threads
  17. aaron_sk
    Post

    AssYriaNrocKer's 94 SingleCab Build Thread

    Nice fix man, and some good tech. I also have a California-spec truck, and for anyone else reading this if you're not sure what you have the...
    Post by: aaron_sk, May 9, 2015 in forum: 1989-1995 Build-Up/Project Threads
  18. aaron_sk
    Post

    1976 SR5 Longbed-stock original(not 4 long)

    Fantastic build! I love how well everything is tucked inside the frame rails. You have ended up with a lot more usable cargo room that way. I'm...
    Post by: aaron_sk, May 8, 2015 in forum: 1976-1983 Build-Up/Project Threads
  19. aaron_sk
    Post

    Timing chain replacement advice please

    By the time you get the valve cover and oil pan off you're already halfway to doing the job. If you can do it yourself just do it, otherwise just...
    Post by: aaron_sk, Oct 21, 2013 in forum: Maintenance/Repair
Find older messages
Showing results 101 to 119 of 119
Search Again
Page 6 of 6