My trucks a rusty POS and sprung a leak in the hard line about 2" outside the tank in the pressure line. Looking to replace the fuel pump hanger assembly, that's the part that holds the pump and lines that bolts onto the tank. it's not listed at any parts places I've seen. I don't care if it's new or old (and not rusted to crap). I've got the fiancees car and a motorcycle but it'd be nice to have the truck running ASAP (like if it's raining and she's out somewhere). plus the apt complex doesn't like work being done to cars in the lot and right now the beds sitting on our patio. vehicle: 1991 pickup 22re short bed short cab 13g tank Located in Carbondale, IL 62901 contact: PM or email (my name on here @yahoo.com) Note the epoxy that turned it from a spray (onto the muffler) to a dribble so I could get home. because of course this happened 160 miles from the family I was visiting with 200 miles left to drive. Thanks Murphey.
i purchased one of those via the dealer a couple years ago. Pricey but it was the only place i could find it.
I tried like hell to get one of these. I ended up cutting the hardline off and drilling it out of the housing then bought new hardline and bent it to shape and used some steel magnesium to seal it up. Here is the link to my build up thread and the page that has the part with the assembly in it. I hope this helps a bit. it was pretty cheap to do and I've had no problems with it since. http://www.toyotaminis.com/forum/bu...25/zombie-monarchs-1991-puckup-build-up-9312/
What shape is it in? How much do you want for it? That's plan B got the bed off yesterday and with the direct sun heating the tank I saw both lines are just perforated.
