I've been looking all over the internet for 4" blocks for my 1979 SR5. I already have 3" blocks in the rear and need to get it down another inch or so. Most websites either offer "universal" options or they say it "won't fit". Building this truck on the cheap and just looking for a simple 4" block and u-bolt set.

Thank you in advance for any help and or suggestions.

P.S I already have the torsions loosened as far as possible and about to do a ball joint flip later this week to get the front even lower.

 

Look at 4x4 lift blocks. Im sure you can find a 4" option for an older vehicle.

 

Yeah that is actually the only place I found 4” blocks but the say “universal fit”, do you think that would be ok? They also didn’t include u-bolts. Was hoping to find something that someone else has had success doing.

 

Found a setup from Rough Country, I’ll update when they deliver if they workout well or not.