Not lowered, quite the oposite, but it's the only rig I've finished so far......
If that was the case there would be loud grinding noise. No way for anything in the drivetrain to slip without any grinding noise. Most...
Yeah, I'm not really sure how my rear shaft came out so good, but it's 100% balanced (I've only had it up to 75mph though) The one I made for...
LOL, I just cut that rod so it is 2" long and zip tied it up to the top.
I can't honestly say that, but it is in the warning on the top right hand side in the article. My rear shaft is so balanced that I drove back...
My version: http://www.ehow.com/how_4475628_build-square-driveshaft.html
http://www.partsamerica.com/ProductDetail.aspx?MfrCode=PBI&MfrPartNumber=647002&CategoryCode=3389D [IMG]
Don't know, but if someone would know, they would. That's why I said call.:D
Call JLevis http://www.jlevisw.com/
And how did you check for vacuum leaks? With more than just your eyes right?
How does your shifter seat look? Replaced mine with one from Marlin Crawler and the problem went away. They cost $10
Here are the frenched spring hangers, should raise the front spring mount at least 3" http://www.concepts2creations.org/SPRING-HANGERS.html...
If you don't want to make them, you can buy the shackle mounts and bushings from Trail-Gear.com [IMG] Once you have those, you just weld...
You must be talking about clamping the leafs to the overload leaf, correct? Why not just french the spring hangers and shackle hanger? Here...
My 85 [IMG] [IMG] [IMG] [IMG] [IMG] Video of wheelin on the Rock Pile at Carnegie http://www.youtube.com/watch?v=YLo9ryOS_uA
Why not install a supercharger and a turbo? Get the best of both...
It lets the hot air out faster making your motor run more efficently. It's done a lot on rodders.
If you are talking about the air intake manifold, yes it's blasted. No paint.
No bead/sand blasting on the carb, that was all polished by hand.
I think the guy was doing crank or something, cause the whole damn thing is polished.....
Separate names with a comma.
