Anyone put a 22re into a 75-78 and find a set of long tube headers that fit and don't end under the trans cross member?
I figured it out. Its 1/8 28 bsp
I measured the size and pitch and came to 3/8-28
It has a connector but im trying to use a plug to plug the hole cause the sensors are ugly
Trying to delete the sensors on the bottom of the brake master. Tho i just realized i didnt look far enough into the tread pitch.
I took the master cylinder to ace hardware and wasn't able to find the right pitch.
Does anyone know the thread pitch for the 2 brake pressure switches on the bottom of a 1975 pickups master cylinder.
Just read up on it, needs to be swapped to an IRS or bent axles. But an IRS is the best idea
Im pretty much trying to find at least another inch out of the rear without running a 5" block
I thought they were a different length.
Currently my front is lowered with might max lowering springs and the rear is 4" angled blocks with a leaf removed. I know that there is a...
I haven't had a chance to add more grounds, but i have been driving it the past few days with no problems. I got another regulator to try too
We checked all the grounds. I could add some. What would be a good place to add one or two?
They are all good didn't see any brakes or bad connections.
So i have replaced the alternator. I tried the new alt with the old reg. At idle with head lights on it will change at 13.4, when i trottle it to...
The new voltage regulator did nothing to the voltage. New alternator comes in tomorrow. That's the last thing it could be as far as i can think of.
I'm in Morgan hill area.
I have replaced the voltage regulator without a change. Got someone else to apply power while i read the volt meter. It got up to about 17 volts....
so had a new problem pop up while i was test driving my truck, all my interior lights and head light get a lot brighter when im driving, and when...
Ok i figured it out. I had made a mistake. Re checked the timing and i was off about two teeth on the distributor. I marked the notches on the...
Separate names with a comma.