Thanks! It is fun when its runnig well! Still need to lean out the weber a little on the idle circuit. Lol The tubes used to go, triange...
[IMG] [IMG] [IMG] [IMG] [IMG] [IMG]
Im just happy to see 2015 as the post date when searching Google for anything pre-tacoma! KBS- Glad to see the Toyota LOVE! Any thoughts on...
brake calipers-yes rotors-yes hubs-yes bearings-yes lower control arms-yes upper ball joints-yes lower ball joints-yes inner & outer tie...
EXACT SAME EXPERIENCE! No spark, no NOTHING. I went back to the 86 ignitor I had been using and it started right up! 84 22r motor new dizzy...
Vibration at speed - You need to go get a center carrier bearing. Pulls to the left- On both my 4wd and 2WD it was old sticking calipers....
HID's pull tons of amps at start-up. Be sure to run a seperate harness triggered by your OEM H4 connector-you will burn up old wiring. AIM YOUR...
Nice seller! Was it making chain noises prior to selling it? How many miles?
Or Ebay, Orieliy's, and NAPA
CAUTION!!! DO NOT REMOVE YOUR EVAP SYSTEM! Or else you WILL smell fuel. I found out the hard way- Use the stock Charcoal canister. Use the...
84-95 (?) pre-tacoma is what your after. I would go so far as to swap in the 90's V6 1ton components and swap in a V6 master while your at it....
most likely you've got 4.10's-it was by far the most popular ratio in the Toyota trucks. 4spd's don't have a OD 5th gear so highways get 'buzzy'....
LPG to petrol right? Honestly don't know much more than their are carb kits for one or the other, same goes with my tri-fuel generator, its...
Sounds like the throttle blades are swinging past Wide Open Throttle then sticking while vacuum is applied-clearing with engine shut down. Try...
yup! single rows came in the later 82-83-84 years in the 22R along with the dreaded plastic guides in order to save cost-this, along with FelPro...
CA opens hoods and checks for smog parts, PDX possibly might, because they want to be better than us 'Washingtonian's"...But in Seattle if your 25...
There is also the Holley 4 barrel or just supercharge it with a Camden kit for all the money spent on head work manifolds and such. Make the...
3/4 ton leafs have a wrap around the front eye, thats possible, as is an add-a leaf, this would be a small spring under the oem spring pack....
I had a shop install mine a few years back. Other than a clunk somewhere in the vacinity of the torn LCA bushhing I can visibly see, they seam to...
To answer the original will it fit question, none of the front suspension will fit the 79+ trucks. They use a torsion bar.
Separate names with a comma.