10 year anniversary! I took my Weber off again and the same issue remains, lol. I have 2 aisin carbs that have been gone through multiple...
Pull them off of the donor or you could fab your own. From above: "the mounts for the frame were off the vehicle i got the bar from, however you...
Can't help there...I went a different route and haven't had any issues since. Only had to cut 1 wire and run 1 fused 12v wire....
Photos of what?
I might make it. Head gasket is in and truck is running ok.
Welcome! Timber tray = flatbed? Love flatbed minis! Post some pics :)
Welcome! There is a meet up here in Sacramento this Sunday: https://toyotaminis.com/forum/threads/2nd-annual-mini-truck-meet-up.25208/
I planned on thinking about going...even though I don't think my truck is anything special AND I have it torn down for an unexpected head gasket...
I believe my bushings were reversed when I got my leafs...just swap the bushings from front to rear and rear to front, so the spring can still be...
Aren't you pretty close to sitting on the axle?
Also, @ least an inch of the drop you get from the beltechs is from what is essentially a block of cut down leaves added to the top of the pack....
I would just put a custom leaf pack together using your existing main leaf...and some donor springs from junk yard trucks. With my beltech leaf...
http://www.hayesautosalesca.com/vehicles/65835e3f-da0b-4cdf-a51b-fd8a48890d1b-1991-Toyota-Pickup-Pick-Up?utm_campaign=1991+Toyota+Pickup&utm_source...
Is location a factor? Where are you located?
http://board.marlincrawler.com/index.php?topic=102504.0
The simple answer is yes, it is possible. I've seen your '79-'83 body swapped onto a newer tacoma frame. But I don't know what was done to make...
Should be pretty close...body mounts could be off or different? I really don't know, but they didn't change too much, if you just wanted to swap...
While taking your readings with your multimeter, maybe you could utilize some jumper cables as temporary grounds?....to see if there is any...
A little more involved, but if you can get the drain plug out...you can always pull an axle and fill through there. Or use it as your overflow...
I've used a Jack and the weight of the truck to pop mine... Put socket/ratchet or breaker bar on bolt, and jack up the handle (i may have used a...
Separate names with a comma.