What are my options? Doesn't look like I can get a replacement heater core (unless I'm missing somthing) so its either pick-n-pull and get lucky...
Can anyone recommend a bushing kit for a 1976? I'm not finding a kit specific for 76 but I imagine that the 79-84 kits I'm seeing would work for...
Anyone running an MSD on their 20r? I would like to make (more) stupid noises.
Someone snag this, I don’t need any more trucks but it looks nice for 5k https://portland.craigslist.org/mlt/ctd/7556235043.html
I’m trying to wire up this tach but I don’t seem to be getting signal from the coil. I’m assuming I’m plugged into the neg side of the coil with...
So my drivers side lower control arm is pretty, but not completely, fucked. Besides a pick'n'pull or junkyard what are my options? It looks like...
Has anyone done these before? It looks pretty straight forward (I’ve done worse motor mounts) but can I get away with jacking it underneath or do...
I just wanted to run this by everyone before I pull the trigger. Crager Nomad 15x7 5x114.3 Offset -6mm Backspace 3.75in Center bore 3.3in/83.82mm...
I've been tearing through all my little projects now, next is to fix the temp gauge. So pictured is what I think is the (2) Water Temperature...
My driver side door stopped opening. I pulled the panel and it looks like the plastic rod clip finally broke. Is 69293-12030 the correct part? I...
Any trick to this or do I just remove the two bolts and loosen the bolt clamping down the splines? Does it just slide off or do I have to pull the...
Anyone know if there are any rainguards/vent visors that fit our trucks? I haven't been able to find anything specific but I'm sure there's got to...
I'd like to get a more flush fit for the wheels. Especially in the rear. Can I get modern 15" steel rims with a higher offset that will fit my old...
Figured I should post an actual build thread as I am nearing completion (hah!). As she was: [IMG] As she is: [IMG] Things to do: Install...
So first off I'm pretty sure I shouldn't have an EGR valve as the truck was de-smogged when the Weber carb was installed by the PO. I'll link to a...
So I ordered a set of fender mirrors and I want to plug the holes in the door. Anyone have a good temp solution. I want to eventually fill with...
So my truck has been shuddering real bad when in reverse and full lock turning. Tires on the rear are getting torn up as well. I checked the oil...
My truck is in desperate need of an overhaul of the steering components. I'm trying to make sure I've got all the pieces needed. Right now in my...
Wrong forum... mods delete?
So I was going to do my carpet but I pulled up the old vinyl to find a real mess. My floor boards are starting to rot through so I'm going to have...
Separate names with a comma.
