It's been a while, but I've got it on 4 inch blocks. It oohs
Looks good, but I think the drive shaft is too far into the trans. I had to make a...
How was the rear lowered?
I have a set of stock springs in selling.
I'll have to come by sometime in person to get thefull experience.
I just got rid of my muffler too. Bit you saw that on IG.
I'll just keep searching elsewhere then.
Has anyone had trouble trying to order from toyheadauto.com?
I sent an email for a quote 2 weeks ago and still no response.
It's looking like I'm just going to order a set of reman calipers, new pads, and new rotors.
I've been looking all weekend, but not much luck yet.
I'm hoping someone has the magic formula of parts. Lol
Truck info: 78 toyota with 22re swap from 92 toyota pickup, also swapped the trans, ecu, full chassis harness, gauge cluster, and steering column....
Anybody got a good source for door locks for my 78?
The 4.10 gears are away too short. I'm curious to see the difference as well. Plus the speedo will read right.
Right now I'm trying to find an axle with 3.58 gears. These 4.10s are way too short.
I just found a few of y'all on IG.
Take a screenshot of the picture and upload that.
I was wrong about the cluncking. Turns out all of my rear lugnuts were loose. Torqued them up and a blast around the block and no more clunking....
Where are you located?
Im in Northern Utah.
I'm going to be looking at a 77 someone is parting out.
Yes, I did. One put up a good fight, but I won. Lol
Will the third member from a 92ish truck with 3.583 gears fit in my axle housing as a direct fit?
I got the calipers done today. Went pretty smoothly, except for the one on the inside drivers caliper that was stuck.
The front passenger still...
I've got them.
If you need more info, look up supra-truck on Facebook.
There is a wealth of knowledge between all the members.
I will if I have any questions.
The parts are expected Saturday.
I'm really hoping I don't have to find new calipers.
Separate names with a comma.