Dash Light change

Discussion in 'Interior/Electronics' started by TRUCK ACTION, May 17, 2018.

  1. TRUCK ACTION

    TRUCK ACTION Grand Toyotaholic

    Joined:
    Jan 5, 2008
    Messages:
    4,188
    Likes Received:
    600
    Location:
    Vallejo,Ca.
    Truck:
    88 Extracab,2wd
    SO I notice the light in my speedo was out, so I had to pull the cluster to check. My cluster is all custom with AutoMeter Phantom gauges & I used LED'S in red which I never thought were bright enough.
    30-40 lumins . So I found some brighter red ones at Supper Bright LED'S, 96 lumins,these are T-3 1/4 bulbs,should have them by tomorrow.
    At the same time I added another resister on my fan controll indictor light which is a small LED & has been back bleeding,hope this fixes 1.jpg 2.jpg that!!
     
  2. Chucky

    Chucky Enthusiast

    Joined:
    Nov 5, 2008
    Messages:
    178
    Likes Received:
    4
    Location:
    Southern Louisiana
    Truck:
    88 pickup reg cab,82 sr5 long bed,93 reg cab sr5
    So that the resister you could dim your leds
     
  3. TRUCK ACTION

    TRUCK ACTION Grand Toyotaholic

    Joined:
    Jan 5, 2008
    Messages:
    4,188
    Likes Received:
    600
    Location:
    Vallejo,Ca.
    Truck:
    88 Extracab,2wd
    The resister is just on one small LED that is on an over ride electric fan switch, comes on when the fan goes on.
    Would bleed back & be on very slightly.
     

Share This Page