Lowered my bro inlaws taco with 2 coil cut on the front springs and 3 inch block in the rear. Added 17 inch black steelies too.

Did front pads on my truck and tied the secondaries. Hopefully picking up some DA integra buckets tonight.

 

... Put it up for trade in the 'For Sale' section ...

 

I turned it into a cow...

 

Mad cow.Got milk?That's a sexy cow.

 

painted my 4x4 valance...and installed my clear corners an signals.

 

had the high pressure power steering line crack and spew all the fluid out while driving down the 15 freeway. didnt know until i went to exit and the truck didnt want to turn anymore.


damn cheap ass autozone hoses only been on for about 6 months. no warnings or leaks until this.

 

Damn that sucks, and definitely a part the should be of high quality. Would hate to be stuck in the middle of nowhere with no steering

 

.......drove 50 miles to a junkyard in Kennedale TX and bought a rear left turn signal/rear light/reverse light lens to replace the cracked one on my 1995 Extended Cab Truck. I was happy to find it!

 

drove to the hardware store, walked around looking for ideas. didnt buy anything. drove to an electronics store, looking for more "sound system" ideas. didnt buy anything. kept telling myself, need to save n spend it on the ****z that matter. slowly walked away n enjoyed the drive home.

 

today i put a thrush turbo muffler and a 3racing exhaust tip with a short pipe on my 85'. sounds deep and throaty. gained about 5-10 hp too.

 

What size in/out did you use? I got the same muffler.

 

Have to stop the work I'm doing on my truck & work on the wife's Mountaineer!
Lost a wheel bearing the other day& to make matters worse,have to replace the spindle!!!

 

oops! i have to re-weld the brackets that hold up my exhaust, im a ****ty welder and only the cat is holding my muffler up. damn, im just glad it didnt come screaming off on the freeway last night.

 

outside diameter is 2 1/8. inside is 2 even.

 

Put gas in it....lol))

 

...drove my truck home n found out i blew my radiator! WTF!!!!!!

any ideas on what kind / where to buy??? was thinking on upgrading to all aluminum one.

 

finally changed my door handle cuz the it broke last month haha

 

Got the upper a-arm off ,lower ball joint, & spindle,now off to the wrecker to get a spindle,& Napa for the rest of the parts. try to get all back on today!!

Will change the passenger side stuff in a month or two,as the ball joints were badly worn,206,000+ miles!!

 

Prim...the aluminum are solid...and just get electric fans so u can take out the stock one...

 

..with this fog going on the morning i had to put back on my wipers