I am wondering as well. I might just order one or two upper control arms for the 89-95 gen truck and see whether it fits right away or needs some...
Back in May I ordered a rear differential on ebay from a 1991-1995 Toyota Previa, it was from a naturally aspirated Previa so it has a 4.30 gear...
I would say use oem if you can. However I swapped a head/gasket/timing chain etc. about 3 years ago and I used a felpro gasket set bought at the...
I would say OEM is best, however I did a head gasket replacement (plus a whole lot more) using a felpro gasket set and it's holding up great,...
Those are valve cover breathers. Often they're for show because they look kind of nice. If you use a weber carburetor for example you may need to...
I just ordered one from LCE and installed it the other day. It took all of 50 minutes and I was taking it easy, 22Rs are so easy to work with....
I am not sure but didn't the 87 model generation have a truckbed without that ridge? At least mine doesn't have it, I thought those ridges were...
Some pointers on how you can fix an idle HC and CO smog test failure. Recently I failed a CA smog test for the first time with high HC and CO...
Good info, thanks. The drain plug on the axle is at the bottom passenger side yes. The other week I got around replacing the axle oil as well,...
I have a rebuilt transmission, 5 speed. The original one was 5 speed and had a cast iron body, I think, it certainly had that look. However I had...
" A decent metallic performance pad will stop well when cold and get better than the cheap pad once it warms up." Yes you're right, also when you...
Here you can see the old rocker arm assembly and valves. The rocker arms were still in good shape, but obviously since I got a new head, valves...
Some more photos, two are a close up of the third cilinder where you can see the scratch in the cilinder wall. So far this hasn't given me any...
Separate names with a comma.