Ok. I will research it. Thank you for the info.
If it is worth taking a look at, I would keep all options open and you can then decide what will work best for your build plans as far as cost and...
They are pretty much the same as Wilwood as far as braking performance and quality product. I just used Strange for my project since it was...
Wilwood brakes on both front and rear will really enhance your braking performance not to mention looking killer on your build. On my other hot...
Nice. Your build is coming along great.
Those are nice tubular A arms you have on your build. I am looking to get a set of those for my truck when I do my coil over setup. I saw the ones...
I also had to install a low profile oil pan for my build because the motor I have is from a Silverado and the pan was too deep for my truck build.
Are you fabricating your own motor mounts or ordering a LS swap kit? I am using the Dirty Dingo brand LS universal hot rod engine mounts and I...
Are you still having clearance issues with the LS6 manifold?
Cory, I ran into the same situation with hood clearance. I wanted to keep the sleeper look with the stock hood so I installed a LS1 low profile...
Yes, I agree. You did do more engineering with your suspension setup. I went with thicker front torsion bars, gas shocks and sway bar for better...
Thanks Cory for the information. I have a set of LS block hugger headers on my engine right now and it works fine. I am running 2 1/4 inch exhaust...
Thank you, Erwin. I appreciate it. I have photos of some stages of the build but I did not know how to upload it on this site. Other builders just...
Welcome Cory, I live in Phoenix and have a 1990 Regular cab with a 5.3 LS with a 4L60e trans setup. I have been driving my truck on a regular...
Thank you for the information, Erik. I appreciate it. I was following the Fabricator series on YouTube and he shows a detailed process in...
Separate names with a comma.