Amazon

 

http://www.amazon.com/Access-35069-...&redirect=true&ref_=oh_aui_detailpage_o08_s00

 

She got a full tune up. New plugs, cap, rotor, new ignitor and coil pack, New Magnacor 8.8mm wires, LCE billet wire loom, LCE Cold air intake, K&N crankcase breather. She runs like a champ.





Mods coming soon. New powder coated intake, bored over throttle body, LCE stainless Air idle screw, LCE Throttle Body spacer, New injectors, all new sensors, new intake studs, 16" electric fan and new alternator.

 

looking real good man. just enuff polish n billet to dress up that engine bay....

 

that "T" cap on your powering steering resevoir, is that off an old toyota and fit right onto that?

 

Honestly I dont know. The truck came with it. They added power steering at some point before I got it.

 

Im planning on polishing or having the reservoir chromed.

 

That cap is standard issue on older trucks. 88 and prior should all have them.

 

Simple! I love it!

 

For plastic parts, you can dye them using rit dye. I've never had issues doing it but always have a backup plan.
I've dyed car parts, RC, toys, etc.

 

Thanks...Getting around to dying my interior door grab handles black.

 

Is this what you use for plastic?

 

Some plastics don't take being dyed very well. Hit the wrecking yards and keep an eye out for late 80's - mid 90's corollas, camrys etc. They often have black or very dark gray interiors and the parts directly interchange.

 

Yeah...Ive been looking for corolla handles in black. I haven't found anything yet. I have 2 sets of door grab handles. I was going to try wrapping one set and see how that works out.

 

does it swap onto the 89-94 trucks?

 

I'm like 95% sure that it does. It's been a long time since I've had a rig with power steering so I won't say 100%.

 

Got my 120 amp alternator in the mail today and I also got my Throttle Body back from Maxbore. I had it rebuilt and bored over to 58mm. $100 shipped is a great price and 2 day turn around time. He also installed and adjusted my new TPS that I sent him as well.

 

So today I finally changed out the windshield wiper linkage. I had a stripped out bolt on the passenger side and I couldn't tighten the nut down on the windshield wiper arm. So I haven't had a working passenger windshield wiper for a little while now. I live in South Florida and its rainy season, so it was time to fix it. Today I got my new windshield wiper linkage from eBay and installed it. I also finally got my new OEM rear quarter wheel house covers. I can finally change out the old faded plastic ones I had. Still working on some other goodies for the engine compartment. Coming soon.

I might install my 4runner SR5 mirrors tomorrow if I have time.

 

Awesome build man, you have great taste. Digging the valance, I may have to pick one up.

 

Where did you pick up the rear plastic from???