I know there is a write up on re drilling the hole for the front hanger , but cannot seem to find it. Can some one direct me, or give me the instructions?

 

Huh

 

Leaf spring hanger....

 

Where you drill a hole higher and farther back than the existing. Looking for the measurements. On the front leaf spring hanger.

 

Thats a popular mod for nissan guys. I remember someone on here doing it. Not much to redrill on these tho

 

But your wheel won't be centered kinda silly to me

 

It will be centered. If you move the joke straight up youl end up with the axle further forward. Move it up and back and your centered. My buddy did it on his hardbody,

 

I installed the four inch blocks, now the rearend seems to be more forward?

 

Looking for w way to center the rearend again.does this lower the truck any when you raise the spring eyelet?

 

Theres no room so it has to be moved forward in less ya weld the old hole up and re drill it at one point I was going to do this

 

Youd have to cut into the frame to move it up and back. Pain in the ass to do to the yotas

 

its not minitruck stuff but it should work good to get another inch or so of drop
Frenched Toyota Leaf Spring Hangers
63" Frenched Leaf Spring Hangers - RuffStuff Specialties
Lets see your frenched spring hangers - Pirate4x4.Com : 4x4 and Off-Road Forum

 

Ok, thanks for the input.

 

I believe it's possible. Nissan guys drill 2" up and either 1/2"-1" back. I was thinking about cutting the hanger off and mounting in the frame rail. I've seen old chevy vans like that. Maybe reinforce the frame with a couple plates but I think it's strong enough already.

 

Maybe like this if the frame rail is not wide enough